Do Wood Floors Have To Be Refinished After Stripping

Your floors are begging you for your help.

Do wood floors have to be refinished after stripping.

When your hardwood turns gray it s definitely time to finish and do it soon before you have more damage. Use a stiff paint brush to spread the stripper over a surface of the wood in a thick even layer. Refinishing is an easy low cost way to bring out natural beauty in wood furniture and make fine details shine. The equipment used in refinishing floors is noisy.

If you have a piece of wooden furniture you really like or a tired thrift store find with loads of potential give it new life with a fresh coat of stain. Choose the best varnish stripper for your needs. Remove the stripper from the wood. Stain is often applied in two coats and can create a strong odor.

Use denatured alcohol in a disposable aluminum pan to clean off the remaining stripper with the help of steel wool. Staining floors especially for first time do it yourselfers is a tricky business. When they polyurethane wears off the wood absorbs the water. Although it gets most of the varnish off the furniture there will be some sanding required after the old finish is removed.

Apply enough stripper to keep the surface wet and never work in direct sunlight as you can dry the wood. If you simply have no floor coverings yet and just a subfloor then you will greatly benefit by painting the walls and ceiling before refinishing the floors. The contractor will sand the old finish off the floors repair any damaged areas and ensure all wood dust is cleared from the floors. Asked this on the flooring forum but not much traffic there these days.

We re doing the entire first floor in two phases due to lack of space to put things it s two phases of sand stain and 3 coats of poly. Hit the area with a putty knife to scrape off the stripper along with the finish. We re getting ready to finish our wood floors some new and some refinish. The job begins after the room is fully cleared.

You can paint with pure freedom even using a paint sprayer and spillages rarely cause much damage. Leaving spots will yield an uneven surface when you finally start finishing it. That water can come from rain snow pet s paws spilled drink or even just cleaning product through normal maintenance. See above for full cure times of our most frequently used wood flooring finishes.

And when it does go wrong the only solution is to re sand the floor and start all over from the beginning. That s why we do our utmost to talk you out of staining your wood floors. No vacuums until floors have fully cured. Chemical stripping products come in a liquid spray or gel form.

Do not use any liquids at all for cleaning any newly refinished hardwood floors until they are fully cured. 24 hours after floors have been sanded and finished they can be swept with a soft bristle broom only. You can do this in two steps. Do not put too much denatured alcohol in the pan as it does tend to quickly evaporate.