Susceptibility in this context is understood to be an indication of how well the signal circuit can differentiate between the undesirable noise and required signal.
Electrical and data separation.
It follows that a data communication physical standard such as rs 232e would have a high susceptibility and a 1000 v 200 a ac cable has a low susceptibility.
Power control wiring separation if you are asking separation needed for interference not code we usually use 12 separation between lv signal cabling and line voltage cabling as a general rule.
Condition 2kva 2 5kva 5kva.
It states separations between supply and communication conduit systems.
The problem is the possibility of induced noise in the signal or data cable.
Unshielded power lines or electrical equipment in proximity to grounded metal conduit pathway.
Unshielded power lines or electrical equipment in proximity to open or non metal pathways.
All data telecommunications or sensitive cabling should not be placed near 3 phase cables as these are normally used for heavy electrical inductive loads e g.
In class 2 and class 3 systems either the voltage or the current depending upon circuit design is limited to a level that will not cause a fire and under.
Air conditioning welding equipment and motors.
They are considered to be a special condition other than a normal power circuit.
While code doesn t mandate any separation imo good practice calls for keeping electrical wiring and signal or data wiring at least several inches apart where they run parallel.
The electrical wiring will not be affected in any way.
There are four classification levels of susceptibility for cables.
The main electrical services entrance is protected with surge arresters transient voltage surge suppressor according to the applicable local national codes for equipment safety.
Minimum separation distance from power source at 480v or less.
All cabling should avoid any proximity to radio or television transmitters beacons and overhead transmission lines.
The national electrical code nec class 2 and class 3 covers remote control signaling and power limited circuits covered by chapter 7 in article 725.
The text in bicsi s tampa fl tdmm can also be found in the national electrical safety code nesc section 320 b 2 separation from other underground installation.